Restore Factory Settings - Xiaomi Roborock 2 Handbuch

Daily Maintenance
Main Unit Sensor
Wipe the sensors of the main unit with a soft, dry cloth, including:
1. The four cliff sensors at the bottom of the main unit.
2. The wall sensor on the right side of the main unit.
3. The charging contact pieces at the bottom of the main unit.
Cliff sensor
Wall sensor
Omni-directional wheel
Charging contact pieces
Side brush
11
Omni-directional wheel
* It is recommended to clean it every month
1. Turn over the machine and take out the omni-directional
wheel by pulling upwards.
2. Clean the hair and dirt off the wheel and the axle.
3. Install the wheel and press it tight.
Note: You may rinse it with tap water and install it after it gets dry
Wheel
Axle
Supporting frame
Dock Charger
It is recommended to clean it every month.
*
Wipe the battery connectors of the dock charger
with a soft, dry cloth.

Restore Factory Settings

If the machine does not function properly after resetting, please
hold the button when the machine is on, and press the rest
button at the same time, until you hear the voice prompt "start
restoring the initial version", then the main unit has been restored
to the factory settings.