Technische Daten; Notes On Safety - Aventics ST6 Betriebsanleitung

AVENTICS | ST6 | R412024085-BAL-001-AC | Deutsch/English
9

Technische Daten

Allgemein
Spannung
Schaltstrom
Umgebungstemperatur
Kabellänge
ATEX
Zone 2
Zone 22
Weitere technische Daten entnehmen Sie bitte dem Online-Katalog
unter www.aventics.com.
English
1 About this Documentation
Documentation validity
These instructions contain important information on the safe and
proper installation and operation of the series ST6-ATEX sensor
(R412022854, R412022856, R412022860, R412022864).
Related documents
The ST6-ATEX sensor is a system component.
O
Also follow the system manufacturer's system documentation.
Presentation of information
Safety instructions
In this document, there are safety instructions before the steps
whenever there is a danger of personal injury or damage to the
equipment. The measures described to avoid these hazards must
be observed.
Safety instructions are set out as follows:
SIGNAL WORD
Hazard type and source
Consequences
O
Precautions
10 bis 30 V DC
≤ 100 mA
–20 °C bis +50 °C
R412022854 3 m
R412022856 5 m
R412022864 0,3 m/M12
R412022860 0,3 m/M8
II 3G Ex nA IIC T4 Gc X
II 3D Ex tc IIIC T135°C Dc X
Warning signs and signal words have the following meanings:
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Symbols
If this information is disregarded, the product cannot be
used or operated optimally.
2

Notes on Safety

About this chapter
The product has been manufactured according to the accepted
rules of safety and current technology. Even so, there is a risk of
injury or damage if the following general safety instructions and
the specific warnings given before the steps in this documentation
are not observed.
O
Read these instructions completely before working with the
ST6-ATEX sensor.
O
Keep these instructions in a location where they are accessible
to all users at all times.
O
Always include the relevant operating instructions when you
pass the ST6 sensor on to third parties.
Intended use
O
The ST6-ATEX sensor is only intended for industrial
applications.
O
The pressure regulator may only be used within the limits
listed in the technical data.
O
The sensor is to be used to detect magnetic fields in explosive
areas.
Improper use
It is considered improper use if the ST6-ATETX sensor
W is used for any application not stated in these instructions or
W is used under operating conditions that deviate from those
described in these instructions.
Personnel qualifications
Assembly and commissioning require basic electrical and
pneumatic knowledge. Assembly and commissioning may
therefore only be carried out by qualified electrical or pneumatic
personnel or an instructed person under the direction and
supervision of qualified personnel. Qualified personnel are those
who can recognize possible hazards and institute the appropriate
safety measures, due to their professional training, knowledge,
and experience, as well as their understanding of the relevant
regulations pertaining to the work to be done. Qualified personnel
must observe the rules relevant to the subject area and have
qualifications according to the Technical Rules for Operational
Safety (TRBS 1203).
WARNING
CAUTION
3