HP q2444b Installationsanleitung Seite 5

CAUTION Do not fan the paper. Fanning can
cause misfeeds.
Load paper into the feeder. The height of the
stack must not exceed the fill marks on the
paper guides (callout 1), and the front edge
of the stack must be aligned with the arrows
(callout 2).
To take advantage of all the feeder
functions, the printer driver on the printer's
host computer must be configured to
recognize the feeder. For Windows
the printer Properties window. On the Device
Settings tab, select the check box for the
1500-sheet feeder.
Close the door on the feeder.
To verify that installation is complete, print a
configuration page from the control panel.
Press to open the printer menus. Press
® , go to
to select INFORMATION, and then press
. Press to select PRINT
CONFIGURATION, and then press
Connect the cables to the rear of the printer
(callout 1). Turn the printer power on (callout
2).
Note
were connected to the printer that are not
shown in this illustration. Make sure that you
connect
connected to the printer.
Make sure that the configuration page lists
the 1500-sheet feeder as an installed
accessory. If the feeder is not listed on the
configuration page, see the use guide on the
CD-ROM that came with the printer.
.
5
There might be additional cables that
all
of the cables that were previously
hp LaserJet
4250/4350 series
1