Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Anti overflow function
To avoid possible overflows related to excessive consecutive inlet of water with the
"BEFORE USE" button, an automatic block is enabled which does not allow more than two
consecutive inlets.
The lock is disabled the next time the macerating pump is activated.
NOTE: effectiveness is not guaranteed if the water inlet level has not been
appropriately set.
The "After Use" cycle will in any case introduce a quantity of water.
If only pump activation is required, see function 2.3.9 Manual pump activation.
Reset
If it is necessary, it is possible to activate the system reset function.
a. Press and hold the LED at the centre (Tank level LED) for 10 seconds.
b. All the LEDs will flash as reset confirmation.
Tecma S.r.l.
Via Flaminia | Loc. Castello delle Formiche
05030 Otricoli (TR)
ITALY
Design and Flexi Line | instructions for installation and use | ENG
53
T +39 0744 709071
F +39 0744 719833
info@tecma.eu
www.thetfordmarine.com
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
