Laser Classification; Fcc Statement; Electromagnetic Compatibility (Emc); Changing/Installing Batteries - RIDGID micro IR-200 Bedienungsanleitung

This equipment is used to make temperature measure-
NOTI E
ments. Incorrect use or improper application may result in incorrect
or inaccurate measurements. Selection of appropriate measure-
ment methods for the conditions is the responsibility of the user.

Laser Classification

The RIDGID micro IR-200 generates a visible laser beam
that is emitted from the front of the device.
The device complies with class 2 lasers according to: EN 60825-
1:1994/A11:1996/A2:2001/A1:2002

FCC Statement

This equipment has been tested and found to comply with the lim-
its for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or tele-
vision reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for
help.
999-995-066.10_REV. D
micro IR-200 Non-Contact Infrared Thermometer

Electromagnetic Compatibility (EMC)

The term electromagnetic compatibility is taken to mean the capa-
bility of the product to function smoothly in an environment where
electromagnetic radiation and electrostatic discharges are present
and without causing electromagnet interference to other equipment.
The RIDGID micro IR-200 conforms to all applicable
NOTI E
EMC standards. However, the possibility of it causing interference in
other devices cannot be precluded.
Figure 4 – Removing Battery Compartment

Changing/Installing Batteries

The micro IR-200 is supplied without a battery installed. If the bat-
tery indicator (Figure 3) displays
placed. Remove the battery prior to long term storage to avoid
battery leakage.
1. Squeeze the battery clips and remove battery compartment
from the thermometer (See Figure 4). If needed, remove bat-
tery.
, the battery needs to be re-
7