Transfer An External Call From Headset To Handset; Flash (Recall) Function; Troubleshooting - Topcom Butler 300 Plus Gebrauchsanweisung

Topcom Butler 300+ Dect Headset
10. TRANSFER AN EXTERNAL CALL FROM
HEADSET TO HANDSET 1
If Handset 1 is registered:
- During a conversation from Headset, press and hold the VOLUME UP (9) or
DOWN (10) key on Headset for a least 3 seconds. Handset 1 will start to ring.
- When Handset 1 picks up you can talk between Headset and Handset 1.
- To transfer the external call from Headset to Handset 1, press the Headset
button (2) shortly.

11. FLASH (RECALL) FUNCTION

You can generate a flash (recall) during conversation with the external line by
pressing and holding the headset button (2) for at least 3 sec.
The flash will generate a network depending function. Please contact your network
provider for further details.

12. TROUBLESHOOTING

Symptom Possible cause
No connection/ Not registered properly
sound between
headset and device
No indication of Headset isn't used for a
charging shown long time and batteries are
completely empty
Headset cannot be - PIN code of the device
registered to a is wrong
device - Battery power is too low
Speaker volume is Wrong volume setting
too low
8
Solution
- Register the handset again
and make sure that both are
within 15m range.
After charging it for 1h it should
lit.
- Refer to the user manual of
the device to change the pin
code to '0000'
- Charge the headset for at
least 6-8 hours
Adjust the volume with the
headset key
Topcom Butler 300+ Dect Headset