Answering Calls; Make An Internal Call From Headset To Handset - Topcom butler 300 plus Gebrauchsanweisung

Topcom Butler 300+ Dect Headset
3 Make sure that the headset is turned ON and remove the rubber cover (5) from
the registration key hole (6).
Press the registration key (6) on the headset to start the registration. The RED
indicator LED will flash rapidly to indicate that the headset is in registration
mode.
When the registration is successful, the GREEN indication LED will flash slowly. If
not, (RED indication LED will flash slowly) you have to repeat step 2 & 3 above.
Make sure your device pin code = '0000'!!!
Note : On each DECT telephone, you can only register a limited number of
devices. (Mostly up to 5 devices). Please check the user guide of your DECT
telephone.
If you have already registered the max. number of devices, you should first
remove 1 device before you can register this DECT headset.

8. ANSWERING CALLS

When the headset rings you will hear a ring tone trough the speaker (3). The
GREEN indication LED will blink fast. Press the headset button (2) once.
You can adjust the volume by pressing the headset button up or down.
To end the call, press the headset button (2) again.
9. MAKE AN INTERNAL CALL FROM
HEADSET TO HANDSET 1
If Handset 1 is registered:
- During Headset standby, press VOLUME UP (9) or DOWN (10) key on
Headset for at least 3 seconds. Handset 1 will start to ring.
- When Handset 1 picks up, the internal conversation can start.
Topcom Butler 300+ Dect Headset 7