Belkin F5D9000 Bedienungsanleitung Seite 13

Installing and Setting up the Card
1B.6
Now secure the Card with the screw that you previously put aside.
1B.7
Carefully screw the antenna onto the threaded connector on the
Card. Turn the antenna until it is vertical, pointing up.
1B.8
Replace the computer's cover. Now that the Card is installed, you
can reconnect the power cord and turn the computer back on.
1B.9 Depending on your computer's
operating system version, the "Found
New Hardware Wizard" might appear
within 3–15 seconds. If it does,
continue to follow the prompts.
Select "Locate and install the driver
software" to continue.
1B.10 You might see a screen similar to
the one pictured below. This DOES
NOT mean there is a problem. Our
software has been fully tested and
is compatible with this operating
system. Select "Install this driver
software anyway" and follow the
on-screen instructions.
1B.11 Next, a screen appears indicating
that hardware installation is taking
place; then, another indicates that
the process is complete.
1B.12 Click "Finish" to complete the
installation.
11 11
1
2
3
4
5
6