Installation - Eiki LC-XN200 Schnellstartanleitung

Installation

Install remote control batteries
① Open the battery
compartment lid.
To ensure safe operation, please observe the following precautions:
● Use two (2) AA or LR6 type batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid matter.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked in the remote control, carefully wipe the case clean and
install new batteries.
● Risk of explosion if two batteries are replaced by an incorrect type.
● Dispose of used batteries according to the instructions on the battery or local
regulations or guides.
6
Remote Control Operating range
Point the remote control toward the projector
remote receiver (front and back) when pressing
any button.
The maximum operating range for the remote
control is about 5 meters and 60 degrees.
② Install new batteries
into the compartment.
③ Replace the
Two AA batteries
For correct polarity
(+ and –), be sure
battery terminals
are in contact
with pins in the
compartment.
compartment lid.