Remote Control Batteries Installation - Eiki LC-NB2W Bedienungsanleitung

ZOOM BUTTON
Used to adjust zoom.
(P20)
FOCUS BUTTON
Used to adjust focus.
(P20)
MUTE BUTTON
Used to mute sound.(P21)
NO SHOW BUTTON
Used to turn the picture
into black image. (P21)
AUTO IMAGE BUTTON
Use to operate AUTO
IMAGE function. (P27)
Remove the battery
1
compartment lid.
Press the lid down-
ward and slide it.
To insure safe operation, please observe the following precautions :
Use (2) AA, UM3 or R06 type alkaline batteries.
Replace two batteries at the same time.
Do not use a new battery with a used battery.
Avoid contact with water or liquid.
Do not expose the Remote Control Units to moisture, or heat.
Do not drop the remote control unit.
If batteries have leaked on the remote control, carefully wipe the case clean and load new batteries.
ON-OFF
COMPUTER VIDEO
ZOOM FOCUS
VOLUME
Used to adjust volume.
(P21)
D.ZOOM
MUTE
Used to turn the projector
into
MENU
mode and resize the
image. (P28)
LASER
Used to stop the picture.
(P21)
KEYSTONE
NO SHOW FREEZE
Used to reset to normal
AUTO IMAGE NORMAL
picture adjustment preset
by the factory. (P26, 30)
Used to correct the
keystone distortion.
(P20, 28, 29)

Remote Control Batteries Installation

Slide the batteries into the
2
compartment.
Operating Range
Point the remote control toward the
projector
whenever pressing the buttons.
VOLUME BUTTON
Maximum operating range for the
remote control is about 5m and 60°
front and rear of the projector
D.ZOOM BUTTON
DIGITAL ZOOM
FREEZE BUTTON
NORMAL BUTTON
KEYSTONE BUTTON
3
Two AA size batteries
For correct polarity (+
and –), be sure the
battery terminals are in
contact with the pins in
the compartment.
BEFORE OPERATION
(Receiver Window)
60°
5 m
5 m
60°
Replace the compartment
lid.
GB
15