Herunterladen Inhalt Inhalt Diese Seite drucken

Facom BSYS.TKVAN Original Bedienungsanleitung Seite 19

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 77
WARNINGS
WARNING
Read the Assembly Instructions entirely before you begin
assembling. Not following the instructions may cause
damage to the van or rack parts and may result in injury
or death.
WARNING
The rack is limited to a load capacity of 70 kg (154 lbs.).
The maximum capacity per
the box itself, is stated on the box and on the Facom
(www.facom.com).
WARNING
Do not drive with passengers in the same cargo area the
Van Racking Solution is installed.
WARNING
Do not use
boxes that are damaged in any way.
WARNING
Appropriate protection in the form of a solid partition
between the cargo area and the driver and passenger
areas is required. The partition should adhere to the safety
standards and regulations in your country.
WARNING
The partition should completely protect the driver and
passengers from the
the modules and any content in case of a crash.
WARNING
The self-tapping fasteners are designed for a single
installation only.
They should not be reused if moving the rack from one van
to another or from one location in the van to another. For
additional information, please refer to your local Facom
service center or www.facom.com.
WARNING
Check the rack and its connecting fasteners regularly and
at least every 5000 km (or 3100 miles).
Toolbox, including
website
®
Van Racking Solution,
®
RACK POSITION AND HEIGHT
Connect the rack only in the area of the van which is a safe
zone for drilling. The recommended zone is between the
wheel-arch (a) and the van partition wall (b).
WARNING
Inspect the area of the van planned for drilling from the inside
and the outside, including under the van floor, and ensure
that there are no wires / tanks / hoses / pipes / etc. in the
vicinity of the drilling zone !
h
a
Van designated connecting zone
Installation must only be done where there is direct access to
the sheet metal of the van body. Remove any kind of cover,
cladding, floor plate, etc
Rack height (h): The rack must reach the stable top
beam. The maximum height of the rack depends on
the kit, and it is marked on the packaging.
The rack must be connected to the van body at three
heights:
Van top beam
Van center beam
Van floor
Before beginning with the assembly process, ensure that
important components, such as first-aid equipment and
vehicle tools, will be easily accessible with the
Van Racking Solution installed.
Solution.
 Note:
The special wooden floor installation kit is designed for the
Sortimo Sobogrip or Soboflex floor plates
EN
VAN TOP BEAM
PARTITION WALL
VAN CENTER
BEAM
b
WHEEL ARCH
VAN FLOOR
Van Racking
3

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Bsys.tkvanl

Inhaltsverzeichnis