Limitation Of Liability - Facom BSYS.TKVAN Original Bedienungsanleitung

EN
Use ANSI Z87.1 safety goggles, hearing protectors,
•
gloves and protective shoes when assembling.
Do not make any modifications to the
•
Racking Solution that are not described in this manual.
Doing so can result in personal injury and or property
damage.
If you are uncertain about any part of the instructions, do
NOT attempt to install the system. Improper assembly of the
system can cause personal injury and or property damage.
If you are unsure or concerned about your ability, seek the
help of professionals with the skills necessary to complete
the assembly.

LIMITATION OF LIABILITY

Facom shall not be liable for any loss or damage, operational
®
loss, loss of profits or corresponding indirect loss arising from
any of the following:
Not following the instructions provided in this manual.
•
Using components or parts other than those provided
•
in this kit; with the exception of Trailer installation
(see Appendix A).
Modifications to the
•
Mounting
•
mounted and closed (or covered).
Loading the rack in excess of 70 kg (154 lbs.)
•
or more than 20 kg (44 lbs.) per pair of brackets
(with the exceptions indicated in the following table).
Modules supported with limitations:
•
MODULE NAME
Tote
Modules that are not supported:
•
MODULE NAME
Radio
Clear Lid
DISPOSAL
The Van Racking Solution should be disposed
of only by authorized recycling companies.
2
Van Racking Solution.
products that cannot be safely
SKU LIMITATION
BSYS.BPT0280 Must be
mounted
under another
box, at the
nearest
available hole.
Gross weight:
15 kg (33 lbs.)
max.
SKU
BSYS.BPMUSIC
BSYS.BPZ100
USING THE RACKING SYSTEM
LOADING AND SECURING THE LOAD
Van
Warning
In the event of an accident, severe braking or acceleration,
objects that are not properly secured can become loose and
can cause injury or death.
Observe the following points when loading the
Van Racking Solution.
Ensure a safe working environment.
•
Place the vehicle on a level and firm surface.
•
Mount the
•
secure it in place.
Place bigger or heavier boxes on the bottom and
•
smaller, lighter boxes towards the top of the rack.
Secure all items not connected to the
•
Van Racking Solution.
After loading, verify that the load is properly secured.
DRIVING AND TRANSPORTING
Crash safety has only been tested for installations specifically
performed as described in this manual.
The
tested at 50 km/hour (20G deceleration), according to ECE
R17 Frontal, when connected directly to the van's metal
frame or to an original Sortimo Sobogrip wooden flooring.
WARNING
Read the Assembly Instructions entirely before you begin
assembling. Not following the instructions may cause
damage to the van or rack parts.
WARNING
This kit requires a solid partition between the cargo area and
the driver and passenger unit, which is not included with this
kit. Check all safety standards and applicable regulations in
your country for cargo partitions.
Facom shall not be responsible for any personal injury or
®
vehicle damage caused by use without the required cargo
partitions.
Emergency braking and or rough road driving may cause
the mounting and connecting fasteners to become loose or
damaged. Loose fasteners can cause severe damage to the
Van Racking Solution or boxes.
Personal injury can occur from loose fasteners and
connections.
Check the connecting fasteners every 5000 km (or
3100 miles) and after emergency braking, and tighten if
needed. If any of the parts is worn or damaged, replace it
immediately or completely remove the system from the van.
storage box on the rack and
Van Racking Solution has been crash