Grohe Europlus serie Montageanleitung Seite 6

GB
Application
Can be used in conjunction with:
• Pressurised storage heaters
• Thermally controlled instantaneous heaters
• Hydraulically controlled instantaneous heaters
Operation with unpressurised storage heaters (displacement
water heaters) is not possible.
Technical data
• Flow pressure
- min.
- recommended
• Operating pressure
• Test pressure
If static pressure is greater than 5 bar, fit pressure reducer.
Avoid major pressure differences between cold and hot water
supply.
• Flow rate at 3 bar flow pressure:
- Spray
- Aerator
- Dishwasher connection
• Temperature:
- Hot water inlet
- Recommended (energy saving)
• Water connection
• Max. clamping length
Note:
All GROHE single-hole mixers with pull-out sprays are
equipped with non-return valves.
3
Installation
Flush pipes thoroughly!
Mount sink mixer, see fold-out page II, Figs. [1] and [2].
Refer to the dimensional drawing on fold-out page I.
Feed the connection hoses separately through the sink,
beginning with the 3/4" connection hose for the dishwasher.
Feed the spray hose (A) through the mixer body from above,
see fold-out page II, Fig. [2].
Note:
0.5 bar
If the support plate (B) is omitted, the clamping length can be
1 - 5 bar
increased by 45mm.
max. 10 bar
16 bar
Connect sink mixer, see Figs. [2] and [3].
- Cold water connection (marked blue)
- Hot water connection (marked red)
- Dishwasher connection
approx. 11.5 l/min
approx. 14 l/min
approx. 15.5 l/min
Connect the spray hose (A), see Figs. [4] to [6].
1. Connect the handspray (C) without using any additional
(maximum): 80 °C
seals to the spray hose (A), see Fig. [4].
60 °C
2. Slide on spring (D) from below.
cold - right
3. Install the snap coupling (E) with O-ring (F) on the end of the
hot - left
spray hose (A) and tighten by hand.
max. 60mm
4. Pull the sleeve (G) of the snap coupling (E) downwards and
fit to the union (H), see Fig. [5].
To ensure that the handspray (C) is correctly seated when
inserted, lug (J) on the outlet must engage in recess on the
handspray (K), see Fig. [6].
Open cold and hot water supply and check connections
for leakage!
= right
= left
= 3/4"