Display - IDEAL AP35 Betriebsanleitung

Display

FILTER CHANGE
• The LED lights up when a fi lter needs to be changed. Acknowledge the alarm when you have
changed the filter (see Page 40).
> There are 3 different ways of acknowledging the alarm and switching off the LED:
- Open and close the filter cover whilst the device is connected to the power supply.
- Keep the IONIZER button in the standby mode pressed for at least 3 seconds (all function
displays are switched off) the filter change display is re-set.
- The filter change display is also reset when you unplug the mains plug from the socket.
Note
The filter change LED also flickers if the fi lter cover is, for instance, defective or damaged.
> Replace the cover with a new one or contact our Service.

• www.krug-priester.com
Service
• service@krug-priester.com
Filter change LED
Contact: Service
35