Packaging; Starting, Operation - Tecsis S4150 Betriebsanleitung

6. Packaging / 7. Starting, operation

6. Packaging

Has everything been supplied?
Check the scope of supply:
Completely assembled pressure switches
„
Inspect the pressure switch for possible damage during transportation. Should there be
„
any obvious damage, inform the transport company and tecsis without delay.
Keep the packaging, as it offers optimal protection during transportation (e.g. changing
„
installation location, shipment for repair).
Ensure that the pressure connection thread and the connection contacts will not be
„
damaged.

7. Starting, operation

Required tools:
for installation:
„
for switch point adjustment:
„
During commissioning of the pressure switch, the corresponding safety regu-
„
!
lations issued by the professional associations and the respective national
conditions are to be considered.
Warning
Use the pressure switch only if it is in a faultless condition as far as the safety-
„
relevant features are concerned.
16 Betriebsanleitung / Operating manual
wrench size 24 (S4150) and size 27 (S4250)
wrench key (2 mm) cross screwdriver (for DIN plug)
flat head screw driver 2.5 x 0.4
(for hysteresis adjustment of S4250)
GB