Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Turn lights off or on and dim then while watching TV
•
Start the coffee from your bedroom when you wake up
•
Turn on lights at night to scare away intruders if you hear a
noise
•
Turn on your electric blanket before the movie ends, so it's
nice and warm to go to bed
To control your lamps and appliances you need Marmitek X-10
Home Automation Modules, which just plug into the existing wall
sockets. No extra wiring is needed. Ask your dealer for more
information.
Controlling Marmitek X-10 Modules
You can control the Marmitek X-10 Modules as follows:
1.
Press and release the Marmitek X-10 button.
2.
Use the number buttons to enter the Unit Code number of the
chosen Module (You do not need to enter '0' first for a single
digit number).
3.
Press the appropriate button for the function you require (see
below).
Marmitek X-10 functions:
On:
Off:
Bright:
Dim:
All Lights On:
All Units Off:
Changing the X-10 House Code
The Marmitek 8 in 1 remote defaults to House Code A, and in most
cases you will not need to change this unless you are experiencing
interference form a neighbouring X-10 system.
1.
Press and release the Marmitek X-10 button.
2.
Press and hold SETUP until the LED indicator lights steadily.
Release the setup button.
3.
Use the number button to enter the number equivalent to the
chosen House Code (1=A, 2=B, .... 16=P).
4.
Press the ENTER button to confirm the House Code. The LED
turns off.
Note: The Housecode you choose must match the Housecode on
the Transceiver Module (TM12 or Marmitek Alarm Console) you are
using it with.
Controlling an IR Mini Controller (IR543)
If you already own an IR Mini Controller, you will need to change
the code in the remote to use it. The code for standard Marmitek
X-10 Home Automation is 013. The code to control the IR mini
Controller is 014. To change the code:
CHANNEL +
CHANNEL -
VOLUME +
VOLUME -
Power
Mute
7
E
NGLISH
Werbung
