Putting Into Operation; Periodical Maintenance - IARP EIS 104 TI Gebrauchs- Und Bedienungs Anleitungen

Warning!
These doors are equipped with an automatic closing system
(counterbalance and pneumatic brake).
During the loading operation, block the door operating on
the specifical lever.
Don't make faster the door running during closing
operation.

PERIODICAL MAINTENANCE

Any further adjustments on the refrigerator necessarily require the electric plug to be removed.
Check periodically the supply cable in order to detect any damage.
If the power supply cable is damaged, don't use the equipment and don't try to repair it: to prevent any
risk, it must be replaced by the manufacturer, by a member of the after-sales service staff, or anyway
by a person having similar qualifications.
In any case, none of the protective elements (the grill, the carter) must be removed by non qualified
staff. Absolutely avoid using the refrigerator without such protection.
The replacement of lamps must be carried out only by an Authorized Service Center.
The lamps have to be replaced by identical lamps only.
For a good preservation of the cabinet's body a periodical cleaning is necessary.
EXTERNAL BODY: when necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEEL SURFACES: wash with warm water and mild detergent, rinse well and dry with
soft cloth. Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL: wash with warm water and mild detergent, rinse well and
dry with soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES: only use products specifically designed for glass cleaning; It is not advisable to
use ordinary water which can leave a film of calcium on the surface of the glass.

PUTTING INTO OPERATION

Check that the voltage on the identification plate
is the same as that of the network.
THE ELECTRICAL SUPPLY LINE TO
WHICH THE REFRIGERATOR WILL HAVE TO
BE CONNECTED IS TO BE PROTECTED BY
A VERY SENSITIVE DIFFERENTIAL SWITCH
(Rc=16A,Dc=30mA); IT IS ALSO TO BE LINKED TO
THE GENERAL EARTHING PLANT.
The manufacturer disclaims all responsability for any damage
to people or things due to incorrect observance of this rule.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords,
adapters or multiple socket outlets to connect the counter.
DIRECTLY connect the equipment to the mains.
-10-