Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Mode To select whether photos or videos should be recorded, select "Photo" or "Video",
or use the Up / Down selector function on the menu. Target selection will be displayed on
the upper left screen. Warning! The camera will automatically switch to "Video" mode as
soon as the "Test" key is activated. Pay attention to the information displayed on the upper
left screen! In the "Photo + Video" mode, the camera will first take a photo and then begin
to record video.
2. Taking a Photo Choose an image size: 20 Mega Pixels (also 16MP, 12MP, 8MP, 5MP, 3MP,
1MP adjustable). The larger the file, the more detailed the picture becomes. But, the maxi-
mum number of high-resolution images on the memory card will be lower.
3. Serial recording Select the number of photos to be taken in sequence when the camera
is activated in photo mode. 1,2,3,6 or 10 pictures or 1 picture + video per triggering adjusta-
ble.
4. Recording a Video Select the screen resolution: (Video length 3 sec. To 10 min. Selecta-
ble). Videos with sound recording of 3840x2160 / 10fps, 2688x1520 / 20fps, 1920x1080 /
30fps, 1280x720 / 60fps, 720x480 / 30fps, 640x480 / 30fps, 320x240 / 30fps adjustable.
Again, the higher the resolution, the sooner the capacity limit of the memory card will be
reached.
5. Time-Lapse: Video resolution 4416x3312, 4000x3000, 3648x2736, 3264x2448
3072x2304 or 2592x1944 pixels adjustable.
6. Video length Use the up / down keys to select the length of a video. Recording (between
3 seconds - 10 minutes). The longer the recording time selected, the shorter the possible
operating time.
7. Sound recording Confirm the function with "On" and you can record the sound during
video recording.
8, Shooting range Use the up / down buttons to select the interval the camera should wait
for before taking the next picture after taking a picture. This prevents too many recordings
from the same event being made.You can choose between 5-60 seconds or 1-60 minutes.
9. Lateral motion detector on / off
10. Sensitivity motion detector With the up / down buttons, the IR range can be set to
near, middle or far away.
The sensitivity of the main motion sensor is set here. For indoor and low noise environments,
select "High". Choose "Medium" for outdoor and environments with a normal amount of Be
movements and select "Low" for environments with a high level of motion. The temperature
can affect the sensitivity. The "High" setting is suitable for warm ambient temperatures, while
"Low" should be selected for cold environments.
13
Werbung
