Olympus PPO-E05 Bedienungsanleitung Seite 13

3. Dismounting the PPO-E05
CAUTION:
• While dismounting the PPO- E05 from the case, water remaining on the PPO-E05 may splatter on the lens
or camera. If this happens, wipe the water off the lens and camera with a dry cloth.
• Make sure that the port is completely dry before dismounting.
1 If any water is on the product, wipe it completely away and
make sure that the product is dry.
2 Holding the PT-E series case firmly with one hand, loosen the
PPO-E05 by turning it about 90 degrees counterclockwise. If
the PPO-E05 is attached too tightly to turn, wrap it with a piece
of rubber or similar non-slip material, and turn it
counterclockwise.
3 After loosening the PPO-E05, point its lens downward and turn
it further counterclockwise until it is separated from the PT-E
series case. Be careful not to drop the PPO-E05 or PT-E
series case.
En
EN 4