Hoover ACENTA Bedienungsanleitung Seite 8

acenta_ECOBOX_v3.qxd
HOOVER RECOMMEND THAT
THE FILTERS ARE WASHED
AFTER FIVE FULL ECOBOX
CONTAINERS.
EMPTYING THE EcoBox™ (7
& 8)
The EcoBox™ check indicator will show
red when the EcoBox™ needs emptying.
For true EcoBox™ check indication the
power control must be set to maximum
(fully to the right).
To empty the EcoBox™:
1. Remove front door.
2. Lift EcoBox™ out of cleaner.
3. Open and empty EcoBox™.
4. Re-assemble EcoBox™.
5. Refit assembled EcoBox™ in cleaner
(reverse of 2).
6. Locate tabs on front door. Close front
door.
CALLING FOR SERVICE
A charge will be made if the cleaner is found to be in working order or has not been
assembled in accordance with these instructions or has been used incorrectly.
Before calling a HOOVER Service Engineer run through the following checklist:
1. Is there a working electricity supply to the cleaner? Check with another
appliance.
2. Is the EcoBox™ full?
3. Is the inlet blocked?
4. Are the filters blocked?
If there is any doubt call your local HOOVER Service Office for advice, they may be
able to assist you over the telephone.
6/7/07 16:38 Page 8
WASHING THE PRE-MOTOR
FILTER (9)
With EcoBox™ removed:
I take out the filter from the housing.
I Rinse the filter under hand warm
water. Do not scrub the filter.
I Remove excess water with a dry
cloth and leave to air dry for 24
hours or until fully dry.
I Refit the clean filter and the
EcoBox™.
WASHING THE EXHAUST
FILTER (10)
I Lift off filter cover.
I Remove filter.
I Rinse the filter under hand warm
water. Do not scrub the filter.
I Remove excess water with a dry
cloth and leave to air dry for 24
hours or until fully dry.
I Refit the clean filter and the cover.
DO NOT use the cleaner without
EcoBox™ in place.
GB