Herunterladen Inhalt Inhalt Diese Seite drucken

Newpol XR1750 Handbuch Seite 12

Inhaltsverzeichnis

Werbung

POSIZIONAMENTO E MESSA IN OPERA
1)
Una volta sballato controllare che la tensione di rete sia la stessa indicata
sulla targhetta caratteristiche.
2)
Se l'apertura delle porte è secondo l'esigenza passare al Punto 3. (Pag. 20)
In caso contrario invertire i punti di incernieramento. Per questa operazione è
consigliabile posizionare l'elettrodomestico in orizzontale adagiandolo molto
delicatamente sullo schienale, usando appositi spessori per evitare lo schiac-
ciamento del condensatore e il danneggiamento del gruppo compressore.
Per effettuare l'inversione delle porte procedere nel seguente modo:
Smontare la cerniera inferiore (A), liberare la bussola (B) e sfilare la porta
1
relativa al congelatore.
POSITIONING AND INSTALLATION
1)
When unpacked, check that the mains voltage is the same as that indicated on
the data plate.
2)
If the door opening is as required, pass to Point 3. (Pag. 20) If not, invert the
hinge points. It is advisable to position the appliance horizontally for this
operation, carefully and very gently placing it on its back, using special stoppers
to prevent squashing the condenser and damaging the compressor unit.
To switch around the doors, proceed as follows:
1
Remove the lower hinge (A), free the bush (B) and slide off the freezer door.
12
B
A
Smontare la cerniera intermedia e sfilare la porta relativa al frigorifero.
2
Svitare il perno superiore e avvitarlo sul lato opposto
3
Remove the middle hinge and slide off the refrigerator door.
2
Unscrew the upper hinge pin and screw onto the opposite side.
3
518

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis