Inhaltsverzeichnis
Werbung
f 2QFH \RX KDYH FKHFNHG IRU OHDNV
turn off the gas, rinse the connecti-
ons with water and dry to prevent the
formation of rust.
f 7XUQ WKH F\OLQGHU NQRE WR WKH OHIW WR
close the cylinder.
Note: the regulator may be different
from the one illustrated here.
WARNING: You must carry out these
leak tests even if your appliance is set
up by the dealer or the shop.
REPLACING THE CYLINDER
When changing the gas cylinder, ensure
that the knobs on the barbecue are in the
OFF position and that the gas cylinder is
closed. Do not replace the gas cylinder
close to anything that may produce a flame
or spark.
TRANSPORT AND STORAGE OF THE
GAS CYLINDER
Although perfectly safe when handled cor-
rectly, lack of caution may result in fire and/
or explosion.
To minimise the risks:
f 1HYHU VWRUH WKH F\OLQGHU LQ D EXLO-
ding, garage or other enclosed area,
but always in a well-ventilated area
f 1HYHU VWRUH WKH F\OLQGHU LQ WKH
vicinity of another gas operated ap-
pliance, or in a very warm area, such
as a car or boat
f $OZD\V NHHS WKH F\OLQGHU RXW RI
reach for children
f $OZD\V WUDQVSRUW DQG VWRUH WKH F\OLQ-
der in an upright position
f 'R QRW VPRNH QHDU WKH JDV F\OLQGHU
USE
PRIOR TO FIRST USE / AFTER
PROLONGED PERIOD OF NON-USE
Do not use the barbecue before you have
read, understood and checked all informa-
tion in this manual.
Ensure that:
f 7KH EDUEHFXH LV FRUUHFWO\ LQVWDOOHG
f 7KHUH LV QR OHDN LQ WKH JDV VXSSO\
VHH ~/HDNDJH WHVW
f 7KH EXUQHUV DUH FRUUHFWO\ LQVWDOOHG
the venturi tubes are properly placed
over the openings of the gas valves
)LJ ' DQG WKHUH DUH QR REVWUXF-
WLRQV VHH VDIHW\ LQIRUPDWLRQ DQG
cleaning of the burners)
f 1RQH RI WKH JDV VXSSO\ KRVHV FDQ
come into contact with a hot surface
f <RXU EDUEHFXH LV LQVWDOOHG LQ D VDIH
place
42
www.barbecook.com
D
LIGHTING THE BURNERS
Prior to lighting the burners, all checks and
procedures detailed in the chapter 'Before
the first use' must have been carried out.
f 7KH OLG RI WKH EDUEHFXH PXVW DOZD\V
EH RSHQ ZKHQ \RX OLJKW WKH EXUQHU V
f 'R QRW EHQG GLUHFWO\ RYHU WKH EDUEH-
FXH ZKHQ OLJKWLQJ WKH EXUQHU V
f 7KH FRQWURO NQREV RI WKH EDUEHFXH
must be 'OFF'. Slowly open the gas
cylinder valve. Before opening the
control knob of one burner, wait ap-
prox. 10 seconds to allow to gas to
stabilize
f ,PSRUWDQW ILUVW OLJKW WKH PLGGOH EXU-
ner
f $V VRRQ DV RQH EXUQHU KDV EHHQ
lighted, you only need to put the con-
WURO NQRE RI WKH RWKHU EXUQHU V LQ WKH
position 'HIGH' to light them.
f 1HYHU WU\ WR OLJKW DOO EXUQHUV DW RQFH
LIGHTING THE BURNERS WITH THE
IGNITER
The battery is not supplied as standard.
f 2SHQ WKH OLG RI WKH EDUEHFXH
f 2SHQ WKH JDV F\OLQGHU YDOYH
f 3UHVV WKH LJQLWHU XQWLO \RX KHDU
sparks
f +ROGLQJ GRZQ WKH LJQLWHU SUHVV WKH
control knob of the middle burner
and turn to 'HIGH'
f ,I WKH EXUQHU GRHV QRW OLJKW DIWHU
attempts, disconnect the gas and
wait 5 minutes before trying again.
This will allow the accumulated gas
to escape. Try again, repeating the
above steps.
f ,I WKH EXUQHU VWLOO GRHV QRW OLJKW UHDG
the chapter 'Troubleshooting Guide'
to determine the cause and the re-
medy, or use a match as described
below.
LIGHTING THE BURNERS WITH A
MATCH
Left and right at the bottom of the burner
box is a small opening that can be used to
light the burners with a match, if the elec-
WURQLF LJQLWHU GRHV QRW ZRUN )LJ *
f 2SHQ WKH OLG RI WKH EDUEHFXH
f 3ODFH D PDWFK LQ WKH PDWFK KROGHU
SURYLGHG )LJ *
f +ROG D EXUQLQJ PDWFK WKURXJK WKH
hole, approx. 13 mm from the burner
f 2SHQ WKH JDV F\OLQGHU YDOYH
f 3XVK WKH UHTXLUHG FRQWURO NQRE DQG
turn to 'HIGH'. The burner should
light within 5 seconds. If not, turn the
control knob off and wait 5 minutes
to allow the gas to escape.
f Repeat steps 1 through 5. If the
burner still does not light after 3
attempts, read the chapter 'Trouble-
shooting Guide'
G
LIGHTING THE OTHER BURNERS
f $V VRRQ DV WKH ILUVW EXUQHU KDV EHHQ
lighted, you only need to put the con-
WURO NQRE RI WKH RWKHU EXUQHU V LQ WKH
position 'HIGH' to light them.
LIGHTING THE SIDE BURNER USING
THE IGNITER
Only for Brahma 3.0 –4.0
223.9340.000 - 223.9923.000
First open the lid of the side burner.
To light the side burner, use the igniter on
the control panel and the control knob on
the side table.
f Press the igniter until you hear
sparks.
f +ROGLQJ GRZQ WKH LJQLWHU SUHVV WKH
control knob of the side burner and
turn to 'HIGH'
f 5HSHDW D QXPEHU RI WLPHV LI WKH
burner does not light immediately.
f ,I WKH EXUQHU GRHV QRW OLJKW DIWHU
5 seconds, turn the control knob to
'OFF' and wait 5 minutes to allow the
gas to escape.
Werbung
Inhaltsverzeichnis
