When The Water System Is Started For The First Time - Electrolux ERES3580 Benutzerhandbuch

If the cabinet is placed in a corner and
the side with the hinges facing the
wall, the distance between the wall
and the cabinet must be at least 230
mm to allow the door to open enough
so that the shelves can be removed.
The power plug must be accessible
after installation of the cabinet.
When the water system is started for
the first time.
The following should be carried out
when the appliance is correctly
connected to the water supply in the
building:
Open the tap on the water connection
and start up the refrigerator. The water
system main valve opens and the
system starts to fill up. Wait for five
minutes.
Unpack the filter provided and connect
it as follows:
- Remove the filter protective cap and
insert the filter connector into the filter
seat and turn as shown in the
illustration (2) until the filter engages
and the projection on the filter
cartridge is opposite the mark on the
plastic cover. See also the illustration
and the instructions on the inside of
the service hatch.
1 2
- Unlock the water dispenser. See the
section "The water dispenser
functions" Select carbonated water
and drain off about 1.5 litres (2.5 pints)
of water. There may be some air to
start with.
Connect the gas cylinder provided as
follows:
- Take out the gas cylinder from plastic
bag and screw the gas cylinder into
the adapter (3) for this purpose, which
is located in the cabinet, doing this by
hand without tools.
3
- Place the gas cylinder with adapter in
the valve and ensure that the valve
bracket hooks are under the
counterhold on the adapter (5). Then
turn up the bracket lever (6) in one
continuous movement. See the
illustration and the instructions on the
inside of the service hatch.
5
4
6
22