Defrosting The Fridge; When The Appliance Is Not In Use; Something Not Working - Electrolux ERES3580 Benutzerhandbuch

Defrosting the fridge

The fridge is defrosted automatically
every time the compressor stops. Frost
formation can be prevented by:
· not putting warm foodstuff inside
the cabinet.
· avoiding frequently opening the
door or keeping it open too long.

SOMETHING NOT WORKING

Before contacting your local Service Force Centre check the following point:
Problem
" " is displayed in the
temperature display.
It is too cold inside the
refrigerator.
It is too warm inside the
refrigerator.
Water comes out on the floor.
The compressor operates
continuously.

When the appliance is not in use

Disconnect the appliance from
electricity supply.
Empty all foods and clean the
appliance, leaving the doors ajar to
prevent unpleasant smells.
If the cabinet is to be kept on, ask
somebody to check it once in a while
to prevent the food inside from spoiling
in case of a power failure.
Possible cause / Remedy
An error has occurred in measuring the
temperature. Call your service representative.
(The cooling system will continue to keep
food products cold, but temperature
adjustment will not be possible.)
Set a warmer temperature.
Set a lower temperature.
Put food products in the right place inside the
refrigerator. See the chapter "Temperature
inside the refrigerator".
Distribute the food products to allow cold air
to circulate around them.
Make sure that the door is completely closed
and that the insulating strip is complete and
clean.
Place the drain hose at the back of the
cabinet above the drain bowl. See the
chapter "Before using the cabinet the first
time".
Set a warmer temperature.
Make sure that the door is completely closed
and that the insulating strip is complete and
clean.
16