Button Function - Helo HNS T1 Produkthandbuch

User and installation manual HNS-T1
Remote control On/Off push button

Button function

The steam generator can be started remotely with the ON/OFF push button. The LED light on the push button
lights up to show that the steam generator has started. The steam generator runs according to the maximum time
and temperature set in the control panel T1. The steam generator can also bu turned off with the push button.
After the steam generator stops the flushing and rinsing functions activate.
See page 5.
The push button is filled with
sealant, therefore it may be installed
in the steam room.
The push button may be installed
through a wall (acrylic walls) or
by making a suitable hole, where
the push button can be embedded and
sealed with appropriate
sealant.
Surface installation boxes may also
be used, if necessary, they do not
need to be tight, because the actual
push button is moisture resistant.
Connection of the push button
11 12 13 14 15 16
Control panel T1 Multiway terminal block
Led indicator
light
ON – OFF button
Retaining nut
46 mm
17 18 19 20 21
40 mm
32 mm
24 mm
On / Off push button
18