Siemens TE506 Gebrauchsanleitung Seite 42

en de
Calc'n'Clean
Duration: approx� 35 minutes�
Calc'n'Clean combines the separate
functions of descaling and cleaning� If both
programmes are due to be run soon, the
espresso machine automatically suggests
this service programme�
Important: If there is a filter in the water
tank (17), it needs to be removed before the
service programme is run�
If the message
Calc'n'Clean required!
appears on the display, press the
button (13) for 3 seconds and then press
the start button (10)� The service pro-
gramme will start�
To run Calc'n'Clean before being prompted,
e
j
off /
press the
least 3 seconds� Then press the
button (13) briefly twice. Turn the upper
rotary knob (15) until
appears in the display� To start
Calc'n'Clean, press the start button (10)�
The display will guide you through the
programme�
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them�
Calc'n'Clean in progress
The appliance rinses twice�
Open drawer
● Open the drawer (4)�
Fill cleaner
● Drop a Siemens cleaning tablet in the
drawer (4) and close�
N.B.: If the water filter (20) is activated,
the display will prompt you to remove the
filter (20) and then press the start button
(10) again. Remove the filter now if you
have not already done so� Press the
start button (10)�
38
e
off /
button (13) for at
e
off /
Start Calc'n'Clean
Fill descaler
Press start
● Pour lukewarm water into the empty
water tank (17) up to the 0.5 l mark and
then dissolve 1 Siemens descaling tablet
TZ80002 in it� When using TZ60002,
2 tablets must be dissolved�
● Press the start button (10)�
Place container
Press start
● Place a receptacle with a capacity of at
least 1 litre under the outlet (6a)�
● Press the start button (10)�
j
Calc'n'Clean in progress
The descaling pro gramme will now run for
about 22 minutes�
Clean / Fill water tank
j
Press start
● Rinse the water tank (17) and refill it with
fresh water up to the max mark�
● Press the start button (10)�
Calc'n'Clean in progress
The descaling pro gramme now runs for
about 10 minutes and rinses the appliance�
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them�
Replace the filter if one is being used. The
appliance has finished cleaning is ready for
use again�
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue� Such residue can
cause corrosion� New sponge cloths may
contain salts. Salts can cause rust film
on stainless steel and must therefore be
washed out thoroughly before use�