ASROCK Fatal1ty Z77 Performance serie Handbuch Seite 32

(9-pin USB_8_9)
(see p.4, No. 27)
USB 3.0 Header
IntA_P4_D+
IntA_P4_D-
(19-pin USB3_4_5)
(see p.4, No. 9)
1
IntA_P5_D+
DUMMY
Infrared Module Header
(5-pin IR1)
(see p.4, No. 29)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.4, No. 32)
1. High Defi nition Audio supports Jack Sensing, but the panel wire on the
chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't need
to connect them for AC'97 audio panel.
E. To activate the front mic.
For Windows
Select "Mixer". Select "Recorder". Then click "FrontMic".
Fatal1ty Z77 Performance Series Motherboard
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
Besides four default USB 3.0
ports on the I/O panel, there is
GND
IntA_P4_SSTX+
IntA_P4_SSTX-
one USB 3.0 header on this
GND
IntA_P4_SSRX+
IntA_P4_SSRX- motherboard. This USB 3.0
Vbus
header can support two USB 3.0
ports.
Vbus
IntA_P5_SSRX-
IntA_P5_SSRX+
GND
IntA_P5_SSTX-
IntA_P5_SSTX+
GND
IntA_P5_D-
This header supports an
IRTX
+5VSB
optional wireless transmitting
DUMMY
and receiving infrared module.
1
GND
IRRX
This is an interface for front
GND
PRESENCE#
panel audio cable that allows
MIC_RET
OUT_RET
convenient connection and
control of audio devices.
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
®
XP / XP 64-bit OS:
31