Unwinding / Winding The Gooseneck; Using The Device; Switching The Borescope On/Off; Lighting - Parkside PKIK 4.3 A1 Bedienungs- Und Sicherheitshinweise

6.4 Unwinding / winding the gooseneck

Unwind or wind the gooseneck to
the desired length.

6.5 Using the Device

6.5.1 Switching the borescope on/off

To switch the borescope on, press and hold the On/Off button [5] for about 3
seconds until the display [1] illuminates. To switch the borescope off, press and
hold the On/Off button [2] for approx. 3 seconds.

6.5.2 Lighting

There are 6 LEDs in the camera head [10]. You can switch on the lighting by
pressing the Light button [7]. Pressing this button multiple times will stepwise
increase the LED brightness. There are 8 adjustable levels. Once the highest
level has been reached, pressing the Light button [7] again will turn the light
off. If you change the brightness setting and then power the camera off and
back on, the light brightness will be reset to the default value.
This is a special lamp not suitable for domestic room illumination
but intended to illuminate the working space only.
PARKSIDE PKIK 4.3 A1
English - 73