Manual Start-Up Sequence - effegibi NUVOLA SMART POWER Bedienungs- Und Wartungsanleitung

NUVOLA SMART POWER OPERATING AND MAINTENANCE MANUAL EN
4.2

MANUAL START-UP SEQUENCE

If a previously installed peripheral device has been disconnected it may be necessary to run a manual
start-up sequence.
Switch on the panel by pressing the "ON/OFF" button (Fig. A).
fig. A
The panel will display all the icons with a dim light.
Buttons A and B, the maintenance signal and the EFFEGIBI logo will appear with a brighter light (see
Fig. B).
fig. B
A B
Press the temperature controls, buttons "C" and "A", firmly and in rapid succession, and they will glow
brighter, and then the "ON/OFF" button. In Fig. C the sequence is shown as numbers"1", "2" and "3".
The "ON/OFF" button (shown as number 3) must be pressed firmly for a few seconds until all the control
panel buttons have been flashing for a few seconds.
fig. C
3
C
A
1
2
35
The data and features referred to are not binding on EFFEGIBI and the company reserves the right to make any appropriate changes
without having to give prior warning or replace this manual.