Initial Operation; Programming; Programming With Lsm Starter - Simons Voss Technologies MK.CD.STARTER.G2 Kurzanleitung

(MK.)CD.STARTER.G2

5 Initial operation

The driver is automatically installed in LSM software Version 3.3 and
higher. Alternatively, you can also find the driver on the SimonsVoss
website (www.simons-voss.com) in the Service area under Software
Downloads. Once the driver is installed, the programming device is
ready for use.

6 Programming

Please observe the system manual for your system:



6.1 Programming with LSM STARTER

The current version of LSM 3.2 or higher must be installed on your
computer. Connect the USB config device. Place the components to be
programmed at a distance of 10-30 cm from the programming device
and implement the programming routines.
If you should receive an error message stating that no hardware has
been found, first check that the USB config device is connected properly
and then verify whether the CDStarter has been detected under
'Programming / Config device' in the software. If there is still an error
message, remove the programming device from the USB socket and
plug it in again. The driver will then be reloaded.
EN
LSM Starter: www.simons-voss.com in the Document area.
MobileKey: www.simons-voss.com in the Document area.
5. Initial operation
23 / 92