Axis P13-E Serie Installationsanleitung Seite 20

AXIS P13-E Series
Read all the instructions before installing the product:
1. Install the wall mount. See Install the Wall Mount on page 20. For detailed instructions,
see the wall mount's Installation Guide, supplied in the package or available on
www.axis.com
2. Attach the housing to the wall mount. See Attach the Housing to the Wall Mount on
page 20.
3. Connect the camera. See Connect the Camera on page 23.
Install the Wall Mount
CAUTION
Make sure that the screws and plugs are appropriate for the material (e.g. wood, metal,
drywall, stone) and that the material is strong enough to support the combined weight
of the camera, housing, and wall mount.
1. Prepare the wall for installation of the wall mount. Use the wall bracket as a template
and mark the holes before drilling the holes.
2. Route the network cable through the wall bracket. Leave approximately 30 cm (11.8 in) of
cable for connecting the camera.
3. If connecting an auxiliary device, for example an I/O, audio, or external power device, to
the camera, repeat the step above as applicable to the specific device.
4. Fasten the wall bracket to the wall by tightening the screws.
Note
• For detailed instructions, see the wall mount's Installation Guide supplied in the package
and available on www.axis.com
Attach the Housing to the Wall Mount
NO NO NO TICE TICE TICE
• Use cables that keep within the specified cable area, see page 18. Using any other than
the provided cable gasket could cause water to seep in and damage the product. For
information about cable gaskets and cable glands that allow for other cable areas, see
www.axis.com
• If more than one cable is used, each cable must be routed through a separate cable gasket.
• Only open a hole in cable gaskets that will be used and if a cable gasket is torn, replace it
with a new cable gasket. Leaving a cable gasket open or using a torn cable gasket could
cause water to seep in and damage the product.
1. Loosen the bottom cover screws and lift the top cover.
2. Select which cable gasket to use and pull the tab to open a hole for the network cable.
20