Cleaning And Maintenance - Stocker 242 Benutzerhandbuch

8
After every spraying operation, the sprayer shall be cleaned to avoid corrosion of tool and
blocking of sprinkler caused by pesticide liquid. In addition, the cleaning can also avoid reducing
the effects of spraying operation or bringing harm to crops when the residue of the pesticide is
different from that of the pesticide of next operation.
Clean the surface of the sprayer with a wet cloth. Shake the sprayer after filling it with water,
and then turn on the power switch to spray the cleaning water through the nozzle. Switch
strainer and spray tank strainer can be disassembled for cleaning with water.
9
The sprayer should be stored in a dry indoor place out of reach of children. Do not keep it upside
down for a long time, which may damage the battery.
64
Art. 242
Electric Backpack Sprayer 15 l

Cleaning and maintenance

Storage
Art. 242
Electric Backpack Sprayer 15 l
Troubleshooting
Problems Causes
1. The pump pressure has
been set at the minimum
value
2. Fuse burn-out
The motor fails to run after
3. Battery out of power
being powered on
4. Power switch has been
damaged
5. Power wires come off
6. Motor damaged
Abnormal sounds heard 1. The fastening screws of
while the motor rotates pump are loosen
1. The inlet and outlet pipes
Leakage occurs to the
of the pump are loosen or
underside of the base
broken
1. Extra-low pump pressure
2. The holes inside the
sprinkler sheet are
blocked
3. The spraying hole and
Poor atomization results
split sheet wears out
4. The spraying sheet has
been inversely assembled
5. Pipe joints may be loosen
6. Battery short of power
For further information about the product, please contact info@stockergarden.com.
Sign up to our newsletter and keep up to date with our latest news info@stockergarden.com
10
Solutions
1. Turn the knob clockwise
to increase the pressure
2. Replace
3. Recharge
4. Replace the switch
5. Disassemble the base to
reconnect the wires
6. Replace the motor
1. Tighten the screws
1. Disassemble the base to
tighten the pipe clam; repair it
1. Turn the knob clockwise
to increase the pressure
2. Remove the impurities
3. Replace the sheets
4. Correct it
5. Tighten the joint
6. Recharge the battery
65