Troubleshooting - Samsung DVD-H1080 Bedienungsanleitung

reference

Troubleshooting

Before requesting service (troubleshooting), please check the following.
Problem
No operations can be
performed with the
remote control.
Disc does not play.
The icon appears
on screen.
Disc Menu doesn't
appear
Play mode differs
from the Setup Menu
selection.
The screen ratio
cannot be changed.
No audio.
The screen is blocked
Forgot password
problems.
The picture is noisy or
distorted
No HDMI output.
Abnormal HDMI output
screen.
HDMI output Jitter
36_ reference
• Check the batteries in the remote control.They may need replacing.
• Operate the remote control at a distance of no more than 20 feet.
• Remove batteries and hold down one or more buttons for several
minutes to drain the microprocessor inside the remote control to reset
it. Reinstall batteries and try to operate the remote control again.
• Ensure that the disc is installed with the label side facing up.
• Check the region number of the DVD.
• The features or action cannot be completed at this time because:
1. The DVD's software restricts it.
2. The DVD's software doesn't support the feature (e.g., angles).
3. The feature is not available at the moment.
4. You've requested a title or chapter number or search time that is out of
range.
• Check if the disc has a Menu
• Some of the functions selected in the Setup Menu may not work
properly if the disc is not encoded with the corresponding function.
• Make sure you have selected the correct Digital Output in the Audio
Options Menu.
• Press the button (on the front panel) for more than 5 seconds with no disc
inside. All settings will revert to the factory settings
• Press the button (on the panel) for more than 5 seconds with no disc inside.
All settings including the password will revert to the factory settings. Don't use
this unless absolutely necessary.
procedure once again.
• If the problem still cannot be solved, please contact your nearest
authorized service center.
• Make sure that the disc is not dirty or scratched.
• Clean the disc.
• Check the Video output is HDMI enabled.
• Check the connection between the TV and the HDMI jack of DVD player.
• See if the TV supports this 480p/576p/720p/1080i/1080p DVD player
• If snow noise appears on the screen, it means that TV does not support
HDCP (High-bandwidth Digital Content Protection).
• Check your TV system setup correctly.
• The screen Jitter phenomenon may occur when frame rate is converted
dia Interface) Output.
• Please refer to the user's manual of your TV.
Action Page
P3
P5
P27~33
P29~30
P28~29
P15
P30~31
P2
P11~12
P11~12
P32~33