Assembly; Handle Assembly - PACLITE Equipment MASTER 600 Bedienungshandbuch

MASTER 600-700-900-1200

HANDLE ASSEMBLY

1. Secure handle in place using M12 x 90 (x1) and M12 x 75 (x1) bolts.
Tighten the bolts to a torque setting of 30Nm.
2. Screw the cable down to it's maximum length so the bolt is at the
bottom of the slot. (See 1)
3. Fit the threaded end of the cable through the hole in the yoke arm
boss. Secure in place using M8 washer and nut. (See 2) Tighten the M8
nut until all play has been removed from the yoke arm.
4. Connect the electrical cable for the centrifugal clutch cutout switch
(See 3).
THROTTLE CABLE ASSEMBLY
1. Remove Air Filter Assembly from the engine (See 4)
2. Set the Throttle Lever on the handle to the idle position. The lever should be in its lowest possible position.
3. Also set throttle lever on the engine to the idle position. (See 4)
4. Thread the throttle cable through the cable clamp (A) so that the metal area located on the end of the cable
is gripped. (See 4)
5. Loosen the screw on the cable clamp (B) and slide the throttle cable through the hole. Re-tighten the screw
so that it grips the cable. (See 4)

Assembly

9