Trouble Shooting - PACLITE Equipment MASTER 600 Bedienungshandbuch

MASTER 600-700-900-1200
Oil Type
GX100
SAE
EX13
10W-3
GX160
EX17
Gearbox EP90
Note:
• Check the gearbox oil at regular intervals and top-up when necessary. Make sure the oil is at the centre
of the sight glass. To find out what grade of oil should be used in the gearbox, please contact the Paclite
Equipment Warranty Department on +33 (0) 1 49 56 02 82.
• Grease Spider Arm Assembly prior to storage and at regular intervals.
Problems Possible Causes
1. No fuel
2. Engine switched off
Engine stops
suddenly or does 3. Spark plug fouled
not run.
4. Engine cold
5. Engine flooded
Disconnected
cutout safety
switch wir
Main shaft
Spider plate
Leaving swirls
in concrete;
rolling concrete;
bouncing.
Blades
Oil/Fuel type & quantity - Spark plug type
Quantity
Fuel Type
(litres)
0.4
Unleaded
0.6
Petrol /
Gasolin
0.6
1.1
Small (0.35)
Large (0.6)

Trouble shooting

Countermeasures
1. Open fuel cap, fill fuel tank
2. Switch engine on
3. Clean & reset plug gap
4. Close choke
5. Open choke, fully open throttle & pull recoil starter until
engine fires.
Reconnect wire
When the machine has a
rolling motion, check the main shaft of the gearbox for any
abnormalities.
Check spider plate for bent trowel arms.
If one is bent, replace it.
1. Check the trowel arms andensure all arms are adjusted
equally.
2. Blades should be of the same dimensions and designed to
fit the machine.
3. Excessively worn blades should not be used.
Capacity Spark plug
(litres) Type
NGK
0.77
(CR5HSB)
2.7
NGK
2.5
BR-6HS
3.6
N/A
Electrode
Gap
0.6-0.7mm
15