Setting The Operating Temperature; Indicator Lights - Teka TGI 200 NF Bedienungsanleitung

en
Setting the operating
temperature
(Fig. 2)
The operating temperature is regulated by the
temperature control.
Warm
1
(Or) Min. (-18 °C)
1 = Lowest cooling setting (Warmest setting)
4 = Highest cooling setting (Coldest setting)
(Or)
Min. = Lowest cooling setting
(Warmest setting)
Max. = Highest cooling setting
(Coldest setting)
Please choose the setting according to the
desired temperature.
The interior temperature also depends on
ambient temperature, the frequency with which
the door is opened and the amount of foods
kept inside.
Frequently opening the door causes the interior
temperature to rise.
For this reason, it is recommended to close
the door again as soon as possible after use.
The normal storage temperature of your
appliance should be -18 °C (0 °F). Lower
temperatures can be obtained by adjusting
the thermostat knob towards Position 4 (or
Max.).
We recommend checking the temperature
with a thermometer to ensure that the storage
compartments are kept to the desired
temperature. Remember to take the reading
immediately since the thermometer
temperature will rise very rapidly after you
remove it from the freezer.
Cold
2 3 4
Max. (-24°C)

Indicator lights

There are three coloured indicator lights located
inside the appliance which show the operating
mode of the freezer (Fig. 2).
Amber Indicator (1)
Illuminates when the fast-freeze switch (4) is
turned on and stays on for maximum 34 hours
or until the fast freeze button is turned off.
Fast-freeze operation is for freezing fresh food
(see Freezing Fresh Food section).
Green Indicator (2)
Illuminates when the appliance is connected
to the mains and will glow as long as there is
electricity present. The green indicator does
not give any indication of the temperature
inside the freezer.
Red Indicator (3)
Illuminates
a. When the internal temperature rises above
-5 °C. (The light turns off when the temperature
cools down to - 9 °C)
b. If the appliance is overloaded with fresh
food.
c. If the appliance door is left open accidentally.
Note: Red indicator light has a built-in delay.
Once the appliance is energized red indicator
light will not illuminate for 24 hours.
Thermostat knob (5)
The thermostat knob is located on the indicator
light frame.
Important:
When you press the fast-freeze switch or adjust
the set temperature, there may be a short
delay before the compressor starts to operate.
This is normal and not a compressor fault.
- E0 blinks on display if there is a freezer
sensor failure.
- E1 blinks on display if there is a defrost
sensor failure.
- E4 blinks on display if there is a heater
failure.
4
en