Connecting Other Equipment; Connecting With Ios Devices; Adjusting The Input Sound - Tascam US-2x2 Bedienungsanleitung

Computer 3-4: Only the signals sent from the
computer by USB are output.
For details about other settings, see "Settings Panel
screen" in "6 – Using the Settings Panel" of the
Reference Manual.

Connecting other equipment

Examples of connections to a US-4x4 (front)
Guitar
Vocal mic Bass Guitar
Examples of connections to a US-4x4 (back)
Powered speakers with
balanced connections
CAUTION
•
Before making connections, turn this unit and all
equipment to be connected off (standby).
•
The phantom power affects both US-2x2 input
channels (all four US-4x4 input channels) simul-
taneously. Do not turn phantom power on when
connecting a mic that does not require phantom
power.
•
Turning phantom power on when a dynamic mic
or other mic that does not require it is connected
could damage this unit and connected
equipment.
•
Do not connect or disconnect mics while
phantom power is on. Doing so could cause
a loud noise and might damage this unit and
connected equipment.
•
Set the LINE OUT and PHONES knobs to their
minimum values before turning phantom
power on/off. Depending on the connected
mics, sudden loud noises from monitoring
Headphones
Vocal mic
USB-B
plug
Drum machine Computer
equipment could occur, and this could damage
the equipment or harm hearing.
•
Supplying phantom power to some ribbon mics
will break them. If you are unsure, do not supply
phantom power to a ribbon mic.

Connecting with iOS devices

US-2x2: You will need a Lightning to USB Camera
Adapter and an AC adapter (sold separately).
1
US-4x4: You will need a Lightning to USB Camera
Adapter.
1
1 You must obtain a genuine Apple Lightning to USB
Camera Adapter separately.
DC5V TASCAM PS-P520 AC adapter (sold separately)
2

Adjusting the input sound

Analog audio signals input into this device from mics,
guitars, keyboards and other audio equipment can be
converted into digital signals and transmitted to the
computer via USB.
You can use the features of this unit to adjust the
digital signals that are sent to the computer.
In addition, by connecting speakers (through an
amplifier if not powered) or headphones to this unit,
you can monitor audio signals that are input to this
unit and output from the computer.
Use the various controls on the front of the unit as
necessary while listening to the input sound.
Example using a US-4x4
3
1 2
Use the GAIN knobs (4) to adjust the analog input
levels of the IN1/IN2 jacks (1) or IN3/IN4 jacks (2,
US-4x4 only) so that the PEAK indicators (3) above
and to the right of the knobs do not light.
To listen to the monitoring signal using headphones,
connect the headphones to the PHONES jack (5)
and adjust the PHONES knob (6).
NOTE
If you cannot hear the input sound through the
headphones or the LINE OUT (BALANCED)
jacks, check the settings of the MONITOR
BALANCE knob on the front of the unit and the
Line Outputs item on the Settings Panel screen.
2
4
TASCAM US-2x2/US-4x4
6
5
11