JSP PowerCap Betriebsanweisung Seite 4

b.2. The "flap" indicator within the airflow device should move into the "green section" which
means that there is adequate airflow for Power Cap to be used.
b.3. In the event of no flow or low flow indicated by a move of the flap into the "red section", first
recheck that battery fitting or charging condition. In the event that there is still no or low airflow,
do not use the Power Cap, but contact JSP Ltd for further advice.
Fitting the visor:-
PowerCap & Powercap Lite
Align the Velcro™ sections on the visor with the Velcro™ sections on the inside of the brim, ensuring that the
visor is central. Press the Velcro™ sections together making certain that the visor is firm against the underside of
the brim.
PowerCap ip
Fitting Faceseal Skirt:-
The skirt is attached to the side of the visor and to the edge of the cap. The edge of the skirt should be pressed
against the Velcro™ strip down the edge of the visor. The skirt will be supplied attached to the edge of the cap.
The skirt should look as shown in the picture below when correctly fitted.
Fitting:-
With sufficient airflow checked as described above, place Power Cap on the head and adjust the sizing band at
the rear of the cap for a snug and firm fit on the head. It is important that the edge seals on the side of the visor
fit closely to the side of the face.
1. Remove the old visor by first pulling out centre of all four
push-rivets and then removing the outer sleeves at all four
points around the carrier.
2. Peel back the protective film from along the top edge of both
sides of the new visor. (NOTE:To prevent fingerprints on the
visor, leave the rest of the film in place).
3. Using the new rivets supplied, attach the left hand side of
the
visor to the left hand side of the visor carrier. Ensuring the rivet
has passed through both sides of the carrier.
4. Repeat the above procedure for all the four rivets around the
visor carrier, some manipulation of the visor maybe necessary
to achieve a tight seal around the circumference
of the visor carrier.
5. Finally remove the rest of the protective film and re-attach
the foam skirt to the Velcro strips.
GB