Werbung
C
Adjustments
22 - Front Pulley Guard Skirt
23 - Locking Nut
24 - Dampening Screw
25 - Work Piece Stop
26 - Upper Support Pad
WARNING!
To reduce the risk of injury, always un-
plug tool before making any adjust-
ments.
Dampening Screw
With the tool properly mounted, the skirt of
the front pulley guard should be resting firmly
against the appropriate dampening screw
(Fig. 4). The dampening screw is preset at
the factory and is intended to prevent vibra-
tion while the tool is in operation. If clear-
ance exists or the tool does not cut smoothly
when in operation, loosen the locking nut,
insert a hex wrench and tighten screw firmly
against the front pulley guard. Tighten the
locking nut after adjusting the dampening
screw.
Adjustments
Once the tool is mounted on the table, check
for proper positioning of the tool and blade
relative to the table. Two simple adjustments
will provide straight, parallel cuts.
Vertical Blade Adjustment
When properly adjusted, the blade should
o
be at a 90
angle with the work surface
(Fig. 5). Insert the hex wrench into the head
of the front handle retaining screw. Place a
square on the work support surface and
against the side of the blade, above the teeth.
Grasp the switch handle and rotate the tool
until the side of the blade is flush with the
vertical side of the square. Firmly tighten the
upper and lower mounting bracket screws.
Parallel Blade Adjustment
Loosen the two swivel bracket clamping nuts
approximately three turns and tap the ends
of the bolts to free them (Fig. 6a). This will
provide maximum movement for adjusting
purposes. Line up the back of the work-
piece stop with the edge of the upper sup-
port pad (Fig. 6b). This will provide clear-
ance between the work piece stop and large
work pieces when the tool is raised to the
"locked" position. Place the square against
the vertical supports of the mounting vice
and the side of the blade, above the teeth
(Fig. 7). Grasp the handle and pivot the tool
until the side of the blade is flush with the
square. Firmly tighten the swivel bracket
clamping nuts (Fig. 6a).
NOTE: After following the complete assem-
bly instructions, make a few trial cuts to be
sure the blade is square with the stock. With
the tool unplugged, make minor adjustments
as necessary.
Vice Assembly
Insert the swivel pin into the hole in the mount-
ing vise and center it. Position the chain hook
with the fingers facing the table and insert
into the recessed hole in the swivel pin.
Thread the crank nut onto the chain hook until
the threads are at least even with the bottom
of the crank nut (Fig. 8).
After the table is completely assembled and
adjusted, place the power cord over the top
of the tool and secure it to the mounting
bracket.
D
Application
27 - Chain Pin
28 - Work Piece
3
English
Werbung
