Sparco F1000KI Bedienungsanleitung Seite 16

Group II/III Car Belt Installation
2.4 Installation of Group II/III and it is for the children
whose weight between 15-36kg.
Before the installation, please take away the
Harness system of baby car seat.
Note: The Harness strap, Harness buckle,
Buckle pads& Shoulder pads should be
stored away safely for future use ( see 3.1
Removing the 5 point harness system and
cover ).
WARNING
Do not to use any load bearing contact points other than
those described in the instructions and marked in the child restraint.
The belt must be routed as shown in the instructions.
Adjust the height of the headrest to suit your
child.
Put the shoulder belt through the shoulder belt
guide under the headrest.
Place your child on the car seat and pass the
belts through the red waist belt guide. Fasten
the car belt with an audible sound "click".
Make sure the Lap belt is stretched as low as
possible over the child's hips, within the belt
guides, and fastened into the buckle. The
shoulder belt must cross-midway between
child's shoulder and neck.
16
Click