BOMANN DU 7605 G Bedienungsanleitung Seite 20

Fig. 2 2 2 2 Fig.
Fig. Fig.
• Before attaching the hood body, insert the two
non-return valves by lightly bending them from
above into the connecting piece (extraction duct)
(Fig. (Fig. 2) 2) 2) 2) (Fig. (Fig.
.
For the extraction mode For the extraction mode: : : :
For the For the extraction mode extraction mode
hose (supplied) with an inner diameter of 150 mm
must be attached. Secure the hose with the enclosed
(Fig. 2a) a) a) a) (Fig. 2 (Fig. 2 (Fig. 2
cable tie .
F F F F ig. ig. ig. ig. 3 3 3 3
• Hang up the hood body. Check the secure hold
and the horizontal position. To secure the hood
body ( ( ( ( C C C C ) ) ) ) , screw in the upper screws 2x
(Fig. 3) (Fig. 3)
ST4*30mm (Fig. 3) (Fig. 3)
• Fix the bracket (with angle) for the upper shaft
closure (A) (A) with the screws 2x ST4*40mm after (A) (A)
determining the extension length of the shaft cov-
(Fig. 4) (Fig. 4) (Fig. 4) (Fig. 4)
er .
For the extraction mode For the For the For the extraction mode: : : : extraction mode extraction mode
of the exhaust hose and connect it with the outlet
opening.
Fig. 2a Fig. 2a
Fig. Fig. 2a 2a
Hereupon a flexible exhaust
Fig. 4 4 4 4 Fig.
Fig. Fig.
.
Check the correct position
Fig. 5 5 5 5 Fig.
Fig. Fig.
• Fasten the outer (lower) shaft with the bracket
(without angle) using the 2x ST4*8mm self-
tapping screws
• Put on the telescope shaft unit; fix the shaft unit
laterally to the hood body with self-tapping screws
2x ST4*8mm and fix the middle shaft bracket (B)
with the screws 2x ST4*40mm.
Pull up the inner shaft and fix the shaft cover lat-
erally to the shaft closure bracket using self-
tapping screws 2x ST4*8mm
Installing the activated carbon filter for reci Installing the activated carbon Installing the activated carbon Installing the activated carbon
mode mode mode mode
• Remove the aluminum grease filter (see "Clean-
ing the aluminum grease filter).
• Place the carbon filter onto the air
intake of the extraction duct.
Make sure that the mounting pins
on the extraction duct engage the mounting slots
of the carbon filter. Turn the filter clockwise until it
clicks into place.
• Reinstall the aluminum grease filter.
Electric Electric Electric Electrical c al connection al c al c onnection onnection onnection
WARNING: WARNING:
WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock shock shock! shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
20
Fig. 6 6 6 6 Fig.
Fig. Fig.
( ( ( ( Fig. Fig. 5) 5) 5) 5) Fig. Fig.
.
(Fig. (Fig. 6 6 6 6 ) ) ) ) (Fig. (Fig.
.
filter for recirculation filter for reci filter for reci
(B)
(B) (B)
rculation rculation rculation
electric
electric electric