Setup And Assembly; Connecting The Ac Power Cable; Connecting The Light Cable - Stryker X8000 Bedienungsanleitung

Setup and Assembly

Note Your local Stryker Endoscopy sales representative will perform
inservice training at your convenience to instruct you and your
staff on the safe and effective operation and maintenance of the
X8000, and to help set up the equipment. Please contact your
local Stryker Endoscopy sales representative to schedule an
inservice after the equipment has arrived.
Note When selecting a setup location for the X8000, consult the
"Electromagnetic Compatibility" section included in this manual
to determine the best location.
To set up the X8000, make the following connections:
• Connect the AC power cable
• Connect the light cable

Connecting the AC Power Cable

1. Plug in the AC power cord to the AC Inlet on the rear console panel.
2. Plug in the other end of the AC cord to a hospital-grade outlet.
W W
ARNING
ELECTRICAL EQUIPMENT
T
PATIENT OR USER
ONLY WITH OTHER
SYSTEMS ARE INSTALLED ACCORDING TO THE REQUIREMENTS OF
IEC 60601-1-1.

Connecting the Light Cable

W U
ARNING
X8000
Note The X8000 Light Source is compatible with all Stryker Light
Cables.
8
X8000
HEN THE
O MINIMIZE LEAKAGE CURRENT THAT MAY TRAVEL TO THE
,
SE ONLY NONCONDUCTIVE FIBEROPTIC CABLES WITH THE
TO MAINTAIN ELECTRICAL ISOLATION
IS INTERCONNECTED WITH OTHER MEDICAL
,
LEAKAGE CURRENTS MAY BE ADDITIVE
T CF
ANY YPE APPLIED PART SHOULD BE USED
T CF
YPE APPLIED PARTS
. E
NSURE ALL
.
.