Unit Installation - Clarion CZ501E Benutzerhandbuch Und Installationhandbuch

Notes of installation
1. Before installation, please make sure
proper connections are conducted and
the unit operates normally. Improper
connection may result in damage to the
unit.
2. Use only accessories designed and
manufactured for this unit and other
unauthorized accessories may result in
damage to the unit.
3. Before installation, please fasten all power
cables.
4. DO NOT install the unit in the place where
close to hot area to prevent damage to
electrical components such as the laser
head.
5. Install the unit horizontally. Installing the
unit more than 30 degree vertically may
result in worse performance.
6. To prevent electric spark, connect the
Dashboard
Mounting Bracket
CMB1525194E(Z501E) manual(SMK).indb
7. DO NOT block the cooling fan exit to

Unit installation

Method A
1. Insert mounting bracket into dash board,
2. Screw in 1 piece of M4×42 to the hole of
3. Slide the unit into the bracket until you hear
Screwdriver
26
positive pole first and then the negative
pole.
ensure sufficient heating dissipation of this
unit, or it may result in damage to this unit.
choose appropriate mounting tab according
to the gap width, bending the mounting
tab outwards with a screwdriver to fix the
mounting bracket in place.
the unit back and put on a rubber cap over
the screw. (see picture below)
a click sound.
Rubber cap
Special Screw (M4x42)
26
2010-12-2 8:56:33