Radio Operations - Clarion CZ501E Benutzerhandbuch Und Installationhandbuch

Audio Setup
pass filter) -> S-W VOL (Subwoofer Volume),
rotate the [VOLUME] knob to select a value.
BALANCE:LEFT 1-7->CENTER->RIGHT 1-7
FADER:FRONT 1-7->CENTER->REAR 1-7

Radio Operations

Select tuner as playing source
Press [SRC / ] button on the front panel or
[SRC] button on the remote control once or
more to enter RADIO mode.
Select one radio band
Press the [BAND/
or [BND/TOP] button on the remote control
to select one radio band among FM1, FM2,
FM3, MW and LW.
Manual tuning
During manual tuning, the frequency will be
changed in steps.
Press the [ ] or [
higher / lower station.
Auto tuning
Press and hold the [
seek a higher / lower station.
To stop searching, repeat the operation
above or press other buttons having radio
functions.
Note:
When a station is received, searching stops
and the station is played.
Preset scan
Preset scan receives the stations stored
in preset memory in order. This function is
useful when searching for a desired station
in memory.
1. Press the [PS/AS] button.
2. When a desired station is tuned in, press
the [PS/AS] button again to continue
receiving that station.
Note:
Be careful not to press and hold the [PS/AS]
button for 1 second or longer, otherwise the
auto store function is engaged and the unit
starts storing stations.
CMB1525194E(Z501E) manual(SMK).indb
] button on the panel
] button to tune in a
] or [ ] button to
12
M-BEX: ON/OFF
LPF: 60/90/120
HPF:60/90/120
SUBW VOL: (-6)-(+6)
Auto store
Only stations with sufficient signal strength
will be detected and stored in the memory.
Press and hold the [PS/AS] button (1 sec.) to
start automatic station search.
To stop auto store, press other buttons
having radio functions.
Notes:
1. After auto store, the previous stored
stations will be overwritten.
2. The unit has 5 bands, such as FM1, FM2,
FM3, MW, LW. FM3, MW and LW can
store by AS function. Each bands can
store 6 stations, CZ501E/CZ501ER/
CZ501EG can store 30 stations in total.
Manual store
When one expected radio station has been
detected, press and hold number button 1~6
to store it in the memory.
Recall the stored stations
Press one numeric button among 1 to 6 on
the panel to select the corresponding stored
station.
Local seeking
When LOCAL seeking is on, only those radio
stations with strong radio signal could be
received.
To open or close LOCAL function, press
and hold the [D] button on the front panel,
then press [ ] button repeatedly until
LO or DX displays on the screen, rotate the
[VOLUME] knob to select Local or Distant
mode.
Note:
The number of radio stations that can be
received will decrease after the local seeking
mode is on.
12
2010-12-2 8:56:30