Maintenance Instructions - Desoutter SC2 Serie Betriebsanleitung

ACCESSORIES
All accessories are available in the following
catalogues:
● Industrial tools
- UK 2050484013
- FR 2050484023
- GER 2050484033
- SP 2050484043
- IT 2050484053
- US 2050484063
- PORT 2050499023
- RUS 2050499013
- CHIN 2050499033
- KOR 2050519203
- MEX 2050519213
LUBRICATION
This is a DRYLINE tool designed to operate on
a totally dry air line i.e. one without any oil or
water moisture. DRYLINE tools can also operate
on a lubricated or partly lubricated air line thus
allowing easy interchangeability with existing
installations.
If lubrication is required an air line lubricator
should be fitted down stream of the filter.
Use ISO VG 15 (27652).
Note: full power is achieved using a lubricated
air supply.
05/2010

MAINTENANCE INSTRUCTIONS

● Service should be carried out at intervals of
1000 hours use.
● All torque figures ± 10%.
● Rubber surfaces should be wiped clean
with a general purpose, non aggressive
degreasant.
When disposing of components,
lubricants, etc... ensure that the relevant
safety procedures are carried out.
WARNING
Never connect a part assembled tool to
the air supply. The rotor blades in this tool
have a PTFE content. The normal health
and safety recommendations concerning
PTFE must be observed when handling
these rotor blades.
● Do not smoke.
● Motor components must be washed
with cleaning fluid and not blown clear
with an air line.
● Wash hands before commencing any
other activity.
6159935410
Issue no : 04
17 / 72