Desoutter SC2 Serie Betriebsanleitung Seite 16

6159935410
Issue no : 04
Original instructions.
© COPYRIGHT 2010, DESOUTTER HP2
7BW UK
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorized parts is not covered by Warranty or
Product Liability.
STATEMENT OF USE
This product is designed for installing and
removing threaded fasteners in wood, metal and
plastic.
No other use permitted. For professional use
only.
The use of spare parts/accessories other than
those originally supplied by the manufacturer
may result in a drop in performance and/or
increased maintenance / noise level / vibrations,
and as the result, the full cancellation of the
manufacturer's liability.
DATA
Weight : 740 g.
Sound pressure level (dBA) :
● 71 ± 2 (EN ISO 15744).
Vibration Level (m/s²) :
● < 2,5 (ISO 8662/1).
Declaration of noise and vibration emission
All values are current as of the date of this
publication. For the latest information please visit
desouttertools.com.
These declared values were obtained by
laboratory type testing in accordance with the
stated standards and are suitable for comparison
with the declared values of other tools tested
in accordance with the same standards. These
declared values are not adequate for use in risk
assessments and values measured in individual
work places may be higher. The actual exposure
values and risk of harm experienced by an
individual user are unique and depend upon
the way the user works, the workpiece and the
workstation design, as well upon the exposure
time and the physical condition of the user.
We, Desoutter, cannot be held liable for the
consequences of using the declared values,
16 / 72
Ø6mm (1/4")
3m
instead of values reflecting the actual exposure,
in an individual risk assessment in a work place
situation over which we have no control.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
An EU guide to managing hand-arm vibration
can be found at http://www.humanvibration.com/
EU/VIBGUIDE.htm.
We recommend a programme of health
surveillance to detect early symptoms which
may relate to noise or vibration exposure, so
that management procedures can be modified to
help prevent future impairment.
OPERATING
With the correct accessory fitted, connect the
tool to the air supply. Grip the tool around the
motor case on the rubber surface and position
the tool into the assemblage that is to be
tightened. Press the lever. The motor starts and
tighten the assemblage to the required torque.
The required torque is achieved by adjusting the
tension on the clutch spring (C). At this point the
internal drive is disengaged and the air to the
motor cut off.
To untighten, press and maintain the button
on the top of the tool (A), position the tool on
assemblage and press on the lever. The motor
starts and untighten the fixing. This button can
be locked in the pressed position if rotated (B).
A
Pmax 6.3 bar
ISO VG15 (27652)
B
2
1
C
Ø12.5 mm (1/2")
05/2010