First Time Start-Up; Twinlux And M3 - invicon Twinlux Gebrauchsinformation

3 First time start-up

3.1 TwinLux and m3

Checking the battery charge
> Check the amount of power left in the battery.
i
NOTE!
Accuracy of the remaining time available
The remaining time indications are only valid at room temperatures
(approx. 18 – 25 ºC) and after the device has been used in continuous operation
for approximately five minutes.
8
8
Indication on the light unit
Battery charge indicator (10)
blinks 1 time
Battery charge indicator (10)
blinks 2 to 3 times
Battery charge indicator (10)
blinks 4 to 5 times
Battery charge indicator (10)
blinks continuously
The light does not switch on when
the on/off switch is pressed
The light switches off automatically Battery
Battery Time remaining on
charge the battery
Full Approx. 30 minutes left
2/3 full Approx. 20 minutes left
1/3 full Approx. 15 minutes left
Battery Approx. 10 minutes left
low
There is enough power left in the
battery to carry out the following
light-curing cycles:
> 10 to 20 curing cycles
of 30 seconds each
> 5 to 10 curing cycles
of 60 seconds each
Battery Connect the power pack to the
empty light unit and the mains and
charge the battery for 7 to 12 hours
Have the light unit checked by an
defective authorized service centre or direct-
ly by Invicon chemical solutions