Carrying Out Light-Curing Cycles; Battery - invicon Twinlux Gebrauchsinformation

4 Operation
3
WARNING!
Light emission of LED source
Direct exposure to the light of the LED light source may cause damage to the eyes.
TwinLux with accessories
> Do not look directly into the LED light source.
1 Power pack plug
> Use the light unit only with a properly mounted and fully functioning
2 Electrical socket
light protection shield.
3 Power pack
> Always make sure that the light protection shield is mounted properly.
4 Cooling vents
> Do not point the light beam of the LED source directly into the eyes.
> Always direct the light beam of the LED light source towards the surface
Power pack (3)
to be polymerized.
TwinLux and m3 are powered by means of the power pack (3) supplied together with
the light unit. To connect the power pack to the light unit, the power pack plug (1) is
connected to the electrical socket (2) at the rear of the light unit.
6
WARNING!
Defective device
Malfunctioning devices or components may cause injury.
> Before each use, check the device for the following:
– The device and its accompanying components are in proper working condition.
– The light protection shield is correctly mounted on the light unit.
– The air vents are free of obstruction.
3 First time start-up
3.1 TwinLux and m3
10
10
Checking the battery charge
7
5
6
8
5 LED light source
6 Stand
7 On/off and timer switch
8 Light protection shield
ches on if the temperature of the heat dissipator rises above 40°C and additional air
ventilation cools the light unit. If the temperature goes back down below 40°C,
the overheating protection system automatically switches off. For m3 – due to reduced
heat build-up – this additional overheating protection system is not necessary.

4.1 Carrying out light-curing cycles

LED light source (5)
WARNING!
Light emission of LED source
Direct exposure to the light of the LED light source may cause damage to the eyes.
5 > Do not look directly into the LED light source.
7
5
7
> Use the light unit only with a properly mounted and fully functioning light
protection shield.
8
> Always make sure that the light protection shield is mounted properly. 8
> Do not point the light beam of the LED source directly into the eyes.
Light emission
> Always direct the light beam of the LED light source directly towards the surface
5 LED light source
to be polymerized.
7 On/off and timer switch
The LED light source (5) comprises two LEDs, which are positioned behind a protective
8 Light protection shield
plexiglass window.
TwinLux
> Mount the light protection shield (8) over the LED light source (5).
> Select the desired curing time by pressing the on/off and timer switch (7) as follows:
On/off switch (7) Curing time
Short touch (< 1 sec) 30 seconds
Short pressure (approx. 2 sec) 60 seconds
Sustained pressure (> 2 sec) Continuous light emission Continuously illuminated
Indication on the light unit
> To interrupt or stop the curing cycle, press again on the on/off switch (7).
Battery charge indicator (10)
blinks 1 time
7
7
8
8
Curing time indicator (11)
Fast blinking
Slow blinking

Battery

Time remaining on
charge the battery
Full Approx. 30 minutes left