Concept KF 1250 Bedienungsanleitung Seite 33

UK
Curling
8 9
The round brush with diameter 30 mm or brush with diameter 22 mm and 20 mm
is intended for curling.
Hold the hair springlets above brush and brush them up properly from bulbs to ends
before curling. Then start curling hair from the ends, unless all ringlet is completed.
Switch on the appliance (position „1" or „2") and leave the hot air working on, unless
hair is not dry (see fig. 4). To fix hair put the switch of functions 3 to „COOL"
(eventually to position „1") and leave cool air working on. Now press the button for
ringlet automatic release and pull out the round brush from ringlet (see fig.5). Then
switch off the appliance.
Fig. 4 Fig. 5
Note
Please be care that the hair springlets would not be too hard.
Please observe that no released hair is sucked in the appliance.
Hair Straightening (at KF 1240, KF 1250)
The hair straightener is suitable for long and short hair.
2
Long Hair:
Dry hair, comb it straight and divide it into some parts. Open the hair straightener and
put the hair springlet into open straightening listels. Close the straightener, switch on the
appliance (position "1" or "2"). Slightly pull from hair bulbs towards ends (see fig.6). To
fix hair put the switch of functions to „COOL" (eventually to position „1") and leave
3
cool air working on. Repeat the procedure and complete hair dressing.
Fig. 6
32 KF 1250, KF 1240, KF 1230, KF 1220, KF 1210