Installation - Taurus ALPATEC BOREAL 12 ELEGANCE Bedienungsanleitung

- Do not use or store the appliance outdoors.
- Do not leave the appliance out in the rain or
exposed to moisture. If water gets into the appli-
ance, this will increase the risk of electric shock.
- Do not touch the plug with wet hands.
- Do not touch any of the appliance's moving
parts while it is operating.
USE AND CARE:
- Fully unroll the appliance's power cable before
each use.
- Do not use the appliance if the on/off switch
does not work.
- Use the appliance handle, to catch it or move it.
- Do not use the appliance if it is tipped up and do
not turn it over.
- Do not turn the appliance over while it is in use
or connected to the mains.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- This appliance is for household use only, not
professional, industrial use.
- Store this appliance out of reach of children and/
or persons with physical, sensory or reduced
mental or lack of experience and knowledge.
- Make sure that dust, dirt or other foreign objects
do not block the fan grill on the appliance.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the appli-
ance from operating correctly.
- Never leave the appliance connected and unat-
tended if is not in use. This saves energy and
prolongs the life of the appliance.
SERVICE:
- Any misuse or failure to follow the instructions
for use renders the guarantee and the manufac-
turer's liability null and void.
DESCRIPTION
A Front grill
B Guard securing
C Front cover
D Spinner lock nut
E Propeller
F Guard lock nut
G Rear grill
H Motor shaft
I Shaft pin
J Oscillation control knob
K Handle
L Motor cover
M Bulge
N Upper stand tube *
O Lower stand tube *
P Stand tube
Q Speed button
R Screw *
S Base plate
(*) Only available on Boreal 16C Elegance
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.

INSTALLATION

- Be sure to remove all packaging material from
inside the appliance.
- Ensure that the fan is switched off from the
supply mains before start any installation or
assembly operation.
- The appliance should be used with its base
fitted.
ASSEMBLING THE BASE (ONLY FOR THE
DESK FAN):
- Put the power cord into the base hole and set
the bulge of stand tube alignment with space of
base hole, and turn the stand tube by clockwise
direction.
ASSEMBLING THE BASE (ONLY FOR THE
STAND FAN):
- Insert the lower stand tube (O) into the base
hole (S) and keep the bulge (M) of the stand
tube alignment with space of the base hole.
- Then use four screws (R) tighten (Fig.1).
- Insert the upper stand tube (N) into the lower
stand tube (O) by hand near the thread zone
and turning it in a clockwise direction (Fig. 2).
ASSEMBLING THE GRILL AND THE PROPEL-
LER:
- Remove the spinner lock nut and guard lock nut
from the motor shaft spindle.
- Fit the rear guard, by positioning on the location
pins.
- Secure the guard to the motor body with the
guard lock nut (Fig. 3).
- Push the fan blade onto the motor shaft by
matching the slots on the base of the blade with
the shaft pin.